Port menu – Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 130

AlliedView™-EMS 4.0.3 Device Management Guide
Page 130 of 468
Event Table
Displays the RMON Event table.
Event Log
Displays the RMON Event log.
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Utilization
Displays the port's utilization information.
Interface Info
Displays port statistics such as the number of frames received and transmitted
on the port, bytes received and transmitted on the port, and port status.
Note
- Valid MIB Set values for the Administration Status parameter are 'up' and
'down'. Attempting to set this parameter to any other value will result in the error
message: "The error occurred with 'Set' operation. Error: gen Error."
Error Statistics
Displays error statistics.
Detail Info
Displays detailed port information such as duplex mode.
Note
- The Port Name parameter is not applicable to the AT-9410GB.
Note
- The current firmware version does not allow the Port VLAN Tag Priority
parameter to be configured. Attempting to configure this parameter will result
in the error message: "The error occurred with 'Set' operation. Error: bad value."
Note
- The Port Transmit Pacing Configuration parameter is not applicable to the
AT-9410GB.
Note
- Device Manager allows the user to disable an active port. However, the disabled
port's Port Link State parameter retains the value 'on-line'.
Note
- When connection is established between a twisted pair port that is configured
to auto-negotiate and a port on another device that is configured to operate at
10/100Mbps full/half duplex, expect the link to drop when the twisted pair port's
speed and mode is changed to match the speed and mode of the port on the
other device.