Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 38)

AlliedView™-EMS 4.0.3 Device Management Guide Page 38 of 468
Mid-level Management
Alarm Options
Displays information about alarm options.
Note - The current firmware version does not allow the Row Status
parameter to be configured. Attempting to configure this parameter to any
valid value will result in the error "The error occurred with 'Set' operation.
Error: gen Error.".
MIB Tree
Displays information about the device's MIB tree.
Tuning
Agent Diagnostics
Displays diagnostic information about the agent.
Note - The Location parameter is not applicable to the AT-8000GS series
and should be ignored.
General Tuning
Displays general tuning information.
Note - The current firmware version returns inconsistent values when
configuring the High Priority and Low Priority parameters.
Note - Valid MIB Set values for the Debug Level parameter should range from
1-100. However, the current firmware version allows the user to enter
values in the range 0-255.
Max Entries Tuning
Displays information about the maximum entries in tuning.
Note - The current firmware version does not allow the following parameters
to be configured:
•
Max IP Next Hop Entries After Reset
•
Max IP Prefixes After Reset
•
Max IP ECMP Entry Size After Reset
•
Max IP Interfaces After Reset
TCP Tuning
Displays the memory pool size for TCP tuning.
Syslog Tuning
Displays the current cache size and its size after reset.
Management ACL Tuning
Displays the current number of access rules and the number after reset.