beautypg.com

Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual

Page 36

background image


AlliedView™-EMS 4.0.3 Device Management Guide

Page 36 of 468

Note

- The current firmware version does not return any value for the Serial

Number parameter.


Stacking Info

Basic Info

Displays the stacking information.

Note

- Stacked devices: The current firmware version does not allow the

Stack Reload Unit parameter to be set to a non-existing Unit ID. Attempting

to do so will result to an error.

Note

- The current firmware version does not allow the Stack Order

Permutation parameter to be configured.

Note

- Valid MIB Set values for the Force Master Unit, Top Unit and Bottom

Unit parameters are [1-2], [1-6] and [1-6] respectively. However, the current

firmware version allows the user to set these parameters to '0'.

Stack Info

Displays information about the stacked devices.

Stack Status

Displays the current unit ID and stack mode of the device after reset.

Note

- Valid MIB Set values for the Active Unit ID After Reset parameter is

[1-6] inclusive. However, the current firmware version allows the user to set

this parameter to '0'.

Stack Unit Mode

Displays the device's current stacking mode.

Cascaded Ports Info

Displays cascaded ports information for stacked devices.

Cascaded Port Config

Displays cascaded port information in a unit after reset.

Note

- Configuring the Row Status parameter to invalid values will not return

an error message except for the 'create and go' value.

Note

- The current firmware version does not allow the Trunk ID After

Reset parameter to be configured.


POE Info

MCU Info

Displays POE device's Microcontroller information.