Port menu – Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 121

AlliedView™-EMS 4.0.3 Device Management Guide
Page 121 of 468
Bridge Port Info
Displays statistics about frames received/transmitted on the switch port.
Note
- The current firmware version returns the value 'NULL' for the Circuit
parameter.
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Interface Info
Displays port statistics such as the number of packets received and transmitted on
the port, bytes received and transmitted on the port and port status. This table also
displays high-capacity port statistics including received and transmitted
unicast/multicast/broadcast packets on the port, link up/down trap and port speed.
Note
- The current firmware version returns a 'noSuchName' value for the following
parameters:
•
Transmitted Buffer Length
•
Received Bytes (HC)
•
Received Unicast Packets (HC)
•
Received Multicast Packets (HC)
•
Received Broadcast Packets (HC)
•
Transmitted Bytes (HC)
•
Transmitted Unicast Packets (HC)
•
Transmitted Multicast Packets (HC)
•
Transmitted Broadcast Packets (HC)
•
Counter Discontinuity Time
To view high capacity (HC) port parameter values, use SNMP v2c.
Note
- Valid MIB Set values for the Port Alias parameter is up to 64 characters.
However, values exceeding 21 characters will be truncated.
Note
- The current firmware version returns the value 'NULL' for the Specific Media
MIB parameter.
Error Statistics
Displays port error statistics such as error frames and collision frames. It also
displays deferred transmissions and ethernet chipset information.
Note
- The current firmware version returns the value '???(0)' for the Duplex Status,
Rate Control Ability, and Rate Control Status parameters.