beautypg.com

Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual

Page 61

background image


AlliedView™-EMS 4.0.3 Device Management Guide

Page 61 of 468

Detail Info

Displays detailed port information such as duplex mode.

Note

- The current firmware version does not allow the following parameters to be

configured:

Tagged Mode

Default Priority

Row Status

Port Flow Control Config

Port Speed

Reactive and Combo Ethernet Config

Attempting to configure these parameters to any valid value will result in the error

"The error occurred with 'Set' operation. Error. bad value." except for the Default

Priority parameter.

Note

- The current firmware version does not allow the Host Mode parameter to be

set to 'multiple-auth' as its value.

Note

- The current firmware version does not allow the Autonegotiation Capabilities

Config parameter to be configured. Attempting to configure this parameter to any

valid value will result in the error "The error occurred with 'Set' operation. Error.

bad value.".

Note

- The Physical Address Type parameter is not applicable to the AT-8000GS

series and should be ignored.

Note

- The current firmware version does not allow the Port Duplex Config

parameter to be set to 'half' as its value.

Note

- The combo ports will not display the Port Context Menu on right-mouse

click if logged-on in an SNMPv3 mode using a user account with no read-write

access to the Transceiver Type parameter.


POE Port Status

Displays additional information for Power Over Ethernet ports.

Note

- Valid MIB Set values for the Port Power Limit parameter is [0 - 2147483647].

However, the current firmware version does not allow this parameter to be

configured to any value. Attempting to configure this parameter from 15401-

2147483647 will result in the error "The error occurred with 'Set' operation. Error:

gen error".