Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 63)

AlliedView™-EMS 4.0.3 Device Management Guide Page 63 of 468
Note - The current firmware version returns a 'noSuchName' value for the
Received Frames (HC) and Transmit Frames (HC) parameters.
Note - The current firmware version does not allow the PAUSE Config
parameter to be set to 'enabledXmit' or 'enabledRcv' as its value.
Port Trunking
Basic Info
Displays basic information about port trunking.
Note - The current firmware version does not allow the Trunk Creation
Support and LACP Membership Restrictions Support parameters to be
configured.
Balancing Criteria
Displays information about Aggregate Index.
Note - The current firmware version does not allow the Used Addresses and
Broadcast Type parameters to be configured.
Aggregator Info
Displays information about every Aggregator that is associated with this
system.
Aggregator Port List
Displays Link Aggregation Control information for every Aggregation Port
associated with this device.
Aggregation Port Info
Displays a list of Link Aggregation Control configuration parameters for each
Aggregation Port on this device.
Note - The current firmware version does not allow the Actor
Administrative Key and Partner Administrative System ID parameters to be
configured. Attempting to configure these parameters to any valid value will
result in the error "The error occurred with 'Set' operation. Error. bad
value.".
Note - Device Manager does not handle 8-bit string parameters correctly. As
a result, the Actor Administrative Status and Partner Administrative Status
parameters will display unrecognizable values and will not be configurable.