Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 402

AlliedView™-EMS 4.0.3 Device Management Guide
Page 402 of 468
MAU Negotiation Info
Displays the MAU's auto-negotiation settings and its status.
Note
- The Administration Status and Restart parameters are implemented as 'read-
only'.
Note
- The Advertised Negotiation Capability parameter is not applicable to the AT-
x900-24X series (AlliedWare Plus) and should be ignored.
Note
- The Negotiation Capability, Advertised Negotiation Capability and Received
Negotiation Capability parameters are not applicable to the AT-x900-24X series
(AlliedWare Plus) and should be ignored.
Note
- The following parameters are not applicable to the AT-x900-24X series
(AlliedWare Plus) and should be ignored:
•
Capability Bits
•
Advertised Bits
•
Received Bits
•
Remote Fault Advertised
•
Remote Fault Received
Note
- When multiple units of the AT-x900-24X series are stacked together, the
'Base Ports' submenu is displayed even if the AT-XEM-STK is the only installed XEM
module in the device.
Aggregator Port List
Displays Link Aggregation Control information for every Aggregation Port
associated with this device.
Note
- The current firmware version returns a 'noSuchName' value for the Partner
Administrative System ID and Partner Operational System ID parameters.
Note
- The current firmware version does not allow the Actor Administrative Status
and Partner Administrative Status parameter to be configured. Attempting to
configure this parameter to any valid value will result in the error "The error
occurred with 'Set' operation. Error: gen error".
Note
- The current firmware version does not allow the following parameters to be
set to '0'.
•
Partner Administrative System Priority
•
Partner Administrative Port
•
Partner Administrative Port Priority