Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 74)

AlliedView™-EMS 4.0.3 Device Management Guide Page 74 of 468
Date and Time
Time Synchronization
Displays the configuration about the device's date/time and time zone.
Note - The current firmware version does not allow DST End and DST Start
parameters to be configured.
Note - Valid MIB Set values for the DST Offset parameter should range from
1 to 1440. However, the current firmware version allows the user to enter
values in the range [-2147483648 to 2147483647] inclusive. Attempting to
enter values greater than 2147483647 will cause the new value to be
converted to its equivalent wrap-around value; i.e., 2147483648 will become
-2147483648, 2147483649 will become -2147483647, and so on.
SNTP/NTP Client Config
Displays information about SNTP/NTP client configuration.
Note - Valid MIB Set values for the Polling Interval parameter should range
from 60 to 86400. However, the current firmware version allows the user to
enter values in the range [-2147483648 to 2147483647] inclusive. Attempting
to enter values greater than 2147483647 will cause the new value to be
converted to its equivalent wrap-around value; i.e., 2147483648 will become
-2147483648, 2147483649 will become -2147483647, and so on.
SNTP Config
Displays information about SNTP client configuration.
Broadcast Mode
Displays information about broadcast mode per interface.
Note - The current firmware version returns a 'noSuchName' value for the
IP Address parameter.
SNTP Server Info
Displays information about trusted SNTP servers to be queried in unicast
or broadcast mode.
Authentication Keys
Displays information about keys information for authentication of NTP packets.
System Log
Basic Info
Displays information and configuration of the device's log files.
Note - Setting the Clear Log File and Clear Cache parameters to a value
other than 0 will delete the log file and clear the cache memory but the value
used will not be retained.