Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 53)

AlliedView™-EMS 4.0.3 Device Management Guide Page 53 of 468
Note - The current firmware version accepts up to 160 characters for the
System Password Level 1 to 15 parameters, including the '#' or '$' character
as directive that indicates the type of password being used. However, using
the '#' character will result to an error.
Method Lists
Displays information about all method lists.
Note - The current firmware version does not allow the Row Status
parameter to be set to 'create and go' or 'destroy' as its value.
Lines
Displays information about all lines, their passwords and their authorization
levels.
Note - The current firmware version does not allow the Row Status
parameter to be configured. Attempting to configure this parameter to any
valid value will result in the error "The error occurred with 'Set' operation.
Error: gen Error".
Note - The current firmware version does not allow the following parameters
to be configured on the implemented data type and range:
•
Method List Name Level 1
•
Method List Name Level 2
•
Method List Name Level 3
•
Method List Name Level 4
•
Method List Name Level 5
•
Method List Name Level 6
•
Method List Name Level 7
•
Method List Name Level 8
•
Method List Name Level 9
•
Method List Name Level 10
•
Method List Name Level 11
•
Method List Name Level 12
•
Method List Name Level 13
•
Method List Name Level 14
•
Method List Name Level 15
As a result, it will display the values: 'enable_n_default', 'enable_c_default',
'login_n_default', 'login_c_default', 'http', 'https' and 'null' as valid values
instead of allowing the user to enter up to 20 characters for these
parameters.
Note - The current firmware version does not allow the Password Valid Time
parameter to be configured.