Port menu – Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 267

AlliedView™-EMS 4.0.3 Device Management Guide
Page 267 of 468
Note
- The current firmware version returns a 'noSuchName' value for the
Additional Info parameter when using an SNMP v1 account.
Error
Displays error statistics.
Note
- The current firmware version returns a 'noSuchName' value for the Error
parameter when using an SNMP v1 account.
History Control Table
Displays the RMON History table.
Note
- The current firmware version is unable to provide History Control Table
information. As a result, the following error message appears: "Failed to get MIB data."
Alarm Table
Displays the RMON Alarm table.
Event Table
Displays the RMON Event table.
Event Log
Displays the RMON Event log.
Port Menu
From the Port menu, you can view and edit MIB information about the port.
Utilization
Displays the port's utilization information.
Interface Info
Standard
Displays port statistics such as the number of packets received and transmitted
on the port, bytes received and transmitted on the port and port status. This
table also displays high-capacity port statistics including received and transmitted
unicast/multicast/broadcast packets on the port, link up/down trap and
port speed.
Note
- Valid MIB Set values for the Administration Status parameter are 'up'
and 'down'. Attempting to set this parameter to any other value will result in
the error message: "The error occurred with 'Set' operation. Error: bad value."
Note
- The current firmware version does not allow the Port Alias parameter
to be configured.
Note
- Use SNMP v2c or v3 to view high capacity (HC) port parameter values.