beautypg.com

Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual

Page 268

background image


AlliedView™-EMS 4.0.3 Device Management Guide

Page 268 of 468

Note

- L3 Models: The current firmware version returns the value 'NULL' for

the Specific Media MIB parameter.

Additional Info

Displays port statistics such as the number of frames received and

transmitted on the port, bytes received and transmitted on the port and port

status.

Note

- Use SNMP v2c or v3 to view this table.


Error Statistics

Standard

Displays port error statistics such as error frames and collision frames.

It also displays deferred transmissions and ethernet chipset information.

Note

- When multiple units of the AT-9400 are stacked together, and the

master switch is an AT-9424Ts or an AT-9424Ts/XP, the current firmware

version returns incorrect values for the Error Statistics parameter.

Note

- L3 Models: The current firmware version returns the value 'NULL' for

the Ethernet Chip Set parameter.


Additional Info

Displays Bad Frames Received and Collision parameters.

Note

- Use SNMP v2c or v3 to view this table.


Detail Info

Displays detailed port information such as duplex mode.

Note

- The Port MDIO parameter is not applicable to the AT-9408LC/SP.

Note

- The Port CoS/QoS Priority and Port STP State parameters are not applicable

to the AT-9400 series and should be ignored.

Note

- Valid MIB Set values for the Port Flow Control and Port Back Pressure

parameters are 'disable' and 'enable'. Attempting to set these parameters to

'unknown' will cause them to be set to 'enable'.

Note

- Configuring the Port HOL Limit parameter of a slave switch to any value

within the range [1-8191] will return a Set Error and will cause the master device to

restart.