Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 408)

AlliedView™-EMS 4.0.3 Device Management Guide Page 408 of 468
Note - Configuring the Save Current Software parameter to values greater
than its valid range will be accepted but will cause the device to restart
intermittently.
Note - The current firmware version allows the Save Current Software
parameter to be set to a 'null' value. However, the Save Current Software
parameter will always return 'saving (null)' value and will not be configurable
unless the switch is restarted.
Note - The SNMP agent may take awhile to respond if the Save Current
Software parameter has been set to 'saving'. When this happens, it may take
a while for device information to be displayed in Device Manager.
Next Boot Firmware
Displays the version of the firmware that the device is currently set to boot
from and its full path.
Backup Firmware
Displays the backup software version and its path in the device.
Software MIB Version
Displays the overall version of the complete set of MIBs that is currently
supported by the software running on the device.
Software License Info
Base License
Displays information about the installed base software licenses on the device.
Installed Licenses
Displays information about the software licenses installed on the device.
Note - The current firmware version returns inconsistent values for the
Index and Stack ID parameters.
Note - Configuring the Row Status parameter to 'destroy' as its value will
result to an error message "The error occurred with 'Set' operation. Error:
time out occurred". However, the value is still set successfully.
Features Info
Displays information about the feature licenses installed on the device.
Install New License
Allows the user to install a new license on the device.
Note - Configuring the Name and Key parameters to value 'NULL' will cause
the device to restart intermittently.