Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 318)

AlliedView™-EMS 4.0.3 Device Management Guide Page 318 of 468
Hardware Info
Installed Modules Info
Displays information about the expansion modules installed in the device.
Note - The current firmware version does not allow the Board Bay
parameter to be configured. Attempting to configure this parameter to any
valid value will result in the error "The error occurred with 'Set' operation.
Error: gen error".
Port Transceivers Info
Displays the type of transceiver on an interface.
Port Events
Displays the number of times that port number values have been re-assigned
since the system was initialized.
Firmware Info
Current Firmware
Displays information about the current software version installed in the
device.
Note - Configuring the Save Current Software parameter to values greater
than its valid range will be accepted but will cause the device to restart
intermittently.
Note - The current firmware version allows the Save Current Software
parameter to be set to a 'null' value. However, the Save Current Software
parameter will always return 'saving (null)' value and will not be configurable
unless the switch is restarted.
Note - The SNMP agent may take awhile to respond if the Save Current
Software parameter has been set to 'saving'. When this happens, it may take
a while for device information to be displayed in Device Manager.
Next Boot Firmware
Displays the version of the firmware that the device is currently set to boot
from and its full path.
Backup Firmware
Displays the backup software version and its path in the device.
Software MIB Version
Displays the overall version of the complete set of MIBs that is currently supported
by the software running on the device.