Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 358)

AlliedView™-EMS 4.0.3 Device Management Guide Page 358 of 468
Interface Info
Standard
Displays high-capacity port statistics including received and transmitted
unicast/multicast/broadcast packets on the port, link up/down trap and port
speed.
Note - The following parameters are not applicable to the AT-x900-12X
series and should be ignored:
•
Specific Media MIB
•
Received Non Unicast Packets
•
Transmitted Non Unicast Packets
•
Transmitted Buffer Length
Note - Device Manager will not display the correct state of the ports and
duplex LEDs if logged-on in SNMPv3 mode using a user account with no read
access to the Interface Info parameters.
Note - When multiple units of the AT-x900-12X series are stacked together,
the 'Base Ports' submenu is displayed even if the AT-XEM-STK is the only
installed XEM module in the device.
Additional Info
Displays port statistics such as the number of frames received and
transmitted on the port, bytes received and transmitted on the port, and
port status.
Note - The current firmware version returns a 'noSuchName' value for the
following parameters:
•
Received Bytes (HC)
•
Received Unicast Packets (HC)
•
Received Multicast Packets (HC)
•
Received Broadcast Packets (HC)
•
Transmitted Bytes (HC)
•
Transmitted Unicast Packets (HC)
•
Transmitted Multicast Packets (HC)
•
Transmitted Broadcast Packets (HC)
Note - The Promiscuous Mode parameter is implemented as 'read-only'.
Note - The Counter Discontinuity Time parameter is not applicable to the
AT-x900-12X series and should be ignored.
Note - Valid MIB Set values for the Port Alias parameter is up to 64
characters. Attempting to enter values greater than the valid range will be
accepted but values exceeding 64 characters will be truncated.