Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 163)

AlliedView™-EMS 4.0.3 Device Management Guide Page 163 of 468
Note - Valid MIB Set values for the Administration Status parameter are 'up' and
'down' only.
Note - The Promiscuous Mode parameter is implemented as 'read-only'.
Detail Info
Displays detailed port information such as duplex mode.
Note - AT-AR770S: The current firmware version always returns 'half-duplex' for the
Duplex Mode parameter regardless of the actual duplex mode of the port.
Error Statistics
Displays error statistics.
Note - The Ethernet Chip Set, Symbol Errors and Duplex Status parameters are not
applicable to the AT-AR700S series and should be ignored.
Spanning Tree Info
Displays the port's spanning tree parameters.
Note - Valid MIB Set values for the Port Path Cost parameter is in the range [1-
65535] inclusive.
MAU Info
Displays interface-related MAU information for the port.
Note - The MAU Type List Bits and HC False Carriers parameters are not applicable
to the AT-AR700S series and should be ignored.
Note - The MAU Status and Default MAU Type parameters are implemented as
'read-only'.
MAU Negotiation Info
Displays the MAU's auto-negotiation settings and its status.
Note - The following parameters are not applicable to the AT-AR700S series and
should be ignored:
•
Capability Bits
•
Advertised Bits
•
Received Bits
•
Remote Fault Advertised
•
Remote Fault Received
Note - The Administration Status, Advertised Negotiation Capability and Restart
parameters are implemented as 'read-only'.