Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 297)

AlliedView™-EMS 4.0.3 Device Management Guide Page 297 of 468
Note - Valid MIB Set values for the Row Status parameter are 'active' and 'not
in service'. Attempting to set this parameter to any other value will result in
error message: "The error occurred with 'Set' operation. Error: bad value".
Port Menu
From the Port menu, you can view and edit MIB information about selected ports.
Utilization
Displays the port's utilization information.
Interface Info
Displays port statistics such as the number of frames received and transmitted on
the port, bytes received and transmitted on the port, and port status.
Note - The current firmware version returns '??? (117)' for the Port Type parameter.
Note - The current firmware version returns the value 0.0 for the Specific Media MIB
parameter which Device Manager interprets as a null value.
Error Statistics
Displays error statistics for the port.
Note - The current firmware version returns the value 0.0 for the Ethernet Chip Set
parameter which Device Manager interprets as a null value.
Detail Info
Port Info
Displays detailed port information such as port type, port link state and port
speed and duplex status.
Port Config
Displays configuration parameters for a particular port such as administration
status and port speed and mode.
Note - The current firmware version does not allow the Port Speed and
Mode parameter to be set to 'other'.
Note - The Port Flow Control parameter is not applicable to the 10Gbps
ports on the AT-XP9700 expansion module.
Spanning Tree Info
STP
Displays information maintained by every port about the Spanning Tree
Protocol.