beautypg.com

Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual

Page 401

background image


AlliedView™-EMS 4.0.3 Device Management Guide

Page 401 of 468

Note

- Valid MIB Set values for the Port Path Cost Config parameter

is [1-200000000] inclusive. However, the current firmware version allows

the user to set this parameter to '0' as its value and will automatically set the

entered value to valid values.

Note

- The current firmware version does not allow the Protocol Migration,

Edge Port, Point-to-Point Config and Port Path Cost Config parameters to be

configured.

Note

- The current firmware version intermittently returns a non-

consecutive order of the port numbering when the XEM module is

interchanged.

Note

- When multiple units of the AT-x900-24X series are stacked together,

the 'Base Ports' submenu is displayed even if the AT-XEM-STK is the only

installed XEM module in the device.


MAC Control Pause

Displays information about the MAC Control Pause function on a single ethernet-

like interface.

Note

- The current firmware version returns a 'noSuchName' value for the Received

Frames (HC) and Transmit Frames (HC) parameters.

Note

- The PAUSE Config parameter is implemented as 'read-only'.

Note

- When multiple units of the AT-x900-24X series are stacked together, the

'Base Ports' submenu is displayed even if the AT-XEM-STK is the only installed XEM
module in the device.


MAU Info

Displays interface-related MAU information for the port.

Note

- The MAU Status and Default MAU Type parameters are implemented as

'read-only'.

Note

- The MAU Type List parameter is not applicable to the AT-x900-24X series

(AlliedWare Plus) and should be ignored.

Note

- The Mau Type List Bits and HC False Carriers parameters are not applicable

to the AT-x900-24X series (AlliedWare Plus) and should be ignored.

Note

- The current firmware version returns the value 'NULL' for the MAU Type

and Default MAU Type parameters.

Note

- When multiple units of the AT-x900-24X series are stacked together, the

'Base Ports' submenu is displayed even if the AT-XEM-STK is the only installed XEM

module in the device.