Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 394)

AlliedView™-EMS 4.0.3 Device Management Guide Page 394 of 468
Note - The current firmware version does not return complete values
for the parameters under the Connection Info table and Device
Manager does not handle Get-Next request for this table correctly.
As a result, the Connection Info parameters display incomplete values.
Remote Connections
Displays information about a particular port component.
Management Addresses
Displays the management address information on the remote system learned
on a particular port contained in the local chassis.
Note - The current firmware version returns the value 'NULL' for the OID
parameter.
Optional TLVs
VLAN Names
Displays the IEEE 802.1Q VLAN name information about the remote
system.
Protocol VLANs
Displays the LLDP Port and Protocol VLAN information about the
remote system.
Protocol IDs
Displays the protocol information about the remote system.
LLDP MED
Device Info
Displays information which describe the device's behavior of the LLDP-MED.
MED Port Config
Displays the LLDP configuration information that controls the transmission
of the MED.
Note - Device Manager does not handle objects of type BITS correctly. As a
result, the MED TLVs Tx Enable parameter will not be configurable and will
display an 8-bit binary string instead of the actual TLV types allowed.
However, the TLV types allowed can still be determined by looking at the
bits that are on from left to right:
•
Bit 0 - Capabilities
•
Bit 1 - Network Policy
•
Bit 2 - Location
•
Bit 3 - Extended PSE
•
Bit 4 - Extended PD
•
Bit 5 - Inventory