Agent menu – Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 112

AlliedView™-EMS 4.0.3 Device Management Guide
Page 112 of 468
Note
- Status information for ports 21 to 24 will always be reflected on both the RJ-45 port
images and the SFP port images regardless of whether it is the RJ-45 or the SFP ports that
are actually in operation. However, if Device Manager detects that the established link
speed is less than 1Gbps, only the RJ-45 port images will turn green.
Note
- When Global RSTP is enabled, the current firmware version sets the Port State
parameter of inactive ports to 'blocking'. As a result, expect port images for inactive ports
to turn yellow in Device Manager.
Agent Menu
From the Agent menu, you can view and edit the system information for the device, or log
into the CLI using Telnet.
System Info
Displays basic system information, including system name, location, contact and
description.
Firmware Info
Displays firmware version.
Network Info
Displays network-related information such as the addresses of the default gateway
and the agents.
Note
- The current firmware version does not allow the Configured IP Address
parameter to be configured.
Manager Address Info
Displays the IP address of the management station.
Note
- The current firmware version does not return the correct values for the Trap
Destination IP Address parameters if these are retrieved in bulk. As a result, all Trap
Destination IP Address parameters will display a value of '0.0.0.0' upon initial display
of the Manager Address Info table. To retrieve the correct values, a Get MIB Value
must be performed on each Trap Destination IP Address parameter, one at a time.
The same is true if their values need to be modified. A Set MIB Value would have to
be performed on each instance of the parameter, one at a time.
DHCP Info
Displays DHCP information including the DHCP System Group and DHCP Timer
Group.
Reset
Resets the switch.
Telnet
Starts a Telnet connection to the switch.