Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 69)

AlliedView™-EMS 4.0.3 Device Management Guide Page 69 of 468
Note - The current firmware version allows the user to enter up to
160 characters for the Serial Number and Asset Tag parameters but
values exceeding 19 characters will be truncated.
Unit Environment Info
Displays the device's main power supply and temperature status.
Physical Entity
Displays the information about the device including the serial number.
Note - The current firmware version accepts up to 6 characters for the
Physical Alias parameter.
Note - The current firmware version accepts up to 16 characters for the
Physical Asset ID parameter.
Note - The current firmware version is unable to display any value for the
Serial Number parameter.
Stacking Info
Basic Info
Displays the stacking information.
Note - Attempting to set the Stack Reload Unit parameter to a non-
existing Unit ID in the stack will cause the master device to restart.
Note - Valid MIB Set values for the Force Master Unit, Top Unit and
Bottom Unit parameters is [1-6] inclusive. However, the current
firmware version allows the user to set these parameters to '0'.
Note - The current firmware version does not allow the Stack Order
Permutation parameter to be configured.
Stack Info
Displays information about the stacked devices.
Stack Status
Displays the current unit ID and stack mode of the device after reset.
Note - Valid MIB Set values for the Active Unit ID After Reset
parameter is [1-6] inclusive. However, the current firmware version
allows the user to set this parameter to '0'.
Cascaded Ports Info
Displays cascaded ports information for stacked devices.