Allied Telesis AlliedView-EMS 4.0.3 Device-Management - Manual (Page 174)

AlliedView™-EMS 4.0.3 Device Management Guide Page 174 of 468
QoS
Displays Quality of Service parameters and allows you to configure Flow Groups,
Traffic Classes, and Policies.
Flow Groups
Displays Flow Group parameters used to group similar traffic flows together.
Note - The current firmware version accepts up to 32 characters for the Description
parameter. NULL values are not allowed.
Traffic Classes
Displays Traffic Class parameters used to provide most of the QoS controls.
Note - The current firmware version accepts up to 32 characters for the Description
parameter. NULL values are not allowed.
Policies
Displays Policy parameters.
Note - The current firmware version accepts up to 32 characters for the Description
parameter. NULL values are not allowed.
Note - The Redirect Port parameter is cleared of its value each time the switch is
restarted.
Note - The current firmware version does not allow the Ingress Port List and Egress
Port List parameters to be set to NULL.
Enable
Enables the port.
Disable
Disables the port.
Port Mirroring
Displays Port Mirroring parameters and allows you to create/delete a port mirror.
Note - The Mirroring Source Module, Mirroring Source Port and Mirroring
Destination Module parameters are not applicable to the AT-8500 series and should
be ignored.
Note - Setting the Port Mirroring Status parameter to 'enabled' without setting the
Mirroring Destination Port parameter to a valid value first will result in the error
message "The error occurred with 'Set' operation. Error: gen Error". However, the
value 'enabled' is still set successfully.
Note - The current firmware version does not allow the Mirroring Destination Port
parameter to be set to 0.