Allied Telesis AlliedView-EMS 4.0.3 Device-Management User Manual
Page 382

AlliedView™-EMS 4.0.3 Device Management Guide
Page 382 of 468
Logical Storage Areas
Displays resource information about the storage devices.
Note
- The current firmware version returns a 'noSuchName' value for the
Allocation Failures parameter.
Note
- The Storage Size parameter is implemented as 'read-only'.
Note
- The current firmware version does not return complete values for the
parameters under the Logical Storage Areas table and Device Manager does
not handle Get-Next request for this table correctly. As a result, the Used
Storage Size parameter displays incomplete values.
Note
- The Allocation Failures parameter is not applicable to the the AT-
x900-24X series and should be ignored.
Host Info
Displays the host information of the device.
Hardware Info
Total Expansion Modules Installed
Displays the number of expansion modules installed in the device.
Installed Modules Info
Displays information about the expansion modules installed in the device.
Note
- The current firmware version does not allow the Board Bay
parameter to be configured. Attempting to configure this parameter to any
valid value will result in the error "The error occurred with 'Set' operation.
Error: gen error".
Port Transceivers Info
Displays the type of transceiver on an interface.
Port Events
Displays the number of times that port number values have been re-assigned
since the system was initialized.
Firmware Info
Current Firmware
Displays information about the current software version installed in the
device.
Note
- Configuring the Save Current Software parameter to values greater
than its valid range will be accepted but will cause the device to restart
intermittently.