Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 423)

MAESTRO Installation and Service Manual 423
Appendix
B
Start and Reset Procedures
Frame Processor
To start or reset the Processor board:
1. Power on.
2. Press the Reset switch S3 (this is a small black momentary switch on the front
edge of processor board, just left of the 9-pin D connector).
3. Telnet to the Processor board. Run the following script commands:
nvRAMmessageclear
startSystem
PCI Panel Server
To reset the PCI Panel Server board, press the “Reset” button on the rear plate.
The PCI Panel Server board must be mounted in a PC (and connected to the
Maestro networks) when there is no hardware control panel in the system.