Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 376)

376 MAESTRO — Installation and Service Manual
Section 13 — DVE Configuration
Note The source that occupies the squeeze window after entering an effect will
always be on the PGM bus regardless of which bus it was on when selected.
The available Enter effect choices are:
• PGM : The PGM source will end in the PGM effect window and the
AUX source will end up in the AUX effect window. No sources inter-
change roles. This effect is accomplished by PGM squeezing into the
PGM effect window revealing AUX squeezing into the AUX effect
window.
• AUX : The AUX source will end up in the PGM window and the PGM
source will end up in the AUX effect window. The PGM source and
AUX source will interchange roles, AUX source will become the PGM
source and PGM source will become AUX source. This is effect is
accomplished by “un-squeezing” AUX on top of PGM with AUX
ending up in the PGM effect window and PGM squeezing into the AUX
effect window.
• PST : The PST source will end up in the PGM effect window and PGM
source will end up as PST. AUX will end up in the AUX effect window
and remain as AUX. PST and PGM will interchange roles. This is effect
is accomplished by performing a full screen transition from PGM to an
existing effect on PST.
Active Effect
Select an Active Effect. When an effect is active (on-air), the “active effect”
selection will determine the available Exit modes.
Note The default exit mode will be to reverse the process used to enter the effect.
In other words, if program was squeezed revealing the AUX video, the default
exit mode is to unsqueeze PGM video and return to PGM full screen. If AUX
video was unsqueezed over PGM, the default exit mode is to squeeze the
PGM (it was AUX when it was selected) until it disappears leaving the original
PGM video full screen. Other exit modes may be available depending on the
choices selected from the list below.