Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 148)

148 MAESTRO Installation and Service Manual
Section 5 — The Maestro Configuration Editor
The 12-character MAC (physical hardware) address is shown on a label
attached to each component.
Note If a component does not appear in the drop-down menu, it may be that the
facility LAN address of the Configuration PC was not set properly, the device
is not powered on, or the Configuration PC is not present on the Facility LAN.
Facility LAN IP Address
This field will be filled in automatically when the facility MAC Address is
selected.
Control LAN IP Address
Enter a corresponding IP address for use on the control LAN.
Note If a control LAN address is entered for the GUI, that address must also be
entered on the GUI Application Settings menu as the “Panel Server IP.”
Repeat the above steps for each Maestro component.
When finished, Click the Apply button, and then the OK button to save the
information.
Note After all the configuration tables are edited and saved you must “compile” the
set before it can be downloaded using the Deployment Control Center. This
process is described in Compile Current Configuration
on page 257 .
Serial Connection
The Automation Connection table has been renamed and is now called the
Serial Connection table. A new row has been added to support EAS Mes-
saging.
This window has a table that defines the connection parameters that
connect the Maestro Master Control system to an Automation system.
When the Serial Connection hyperlink is selected, the Set Panel will then
open.