Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 108)

108 MAESTRO — Installation and Service Manual
Section 3 — Hardware Installation
2, 3/4, and 5/6 connectors provide 5.1 surround monitoring (see
Figure 52 on page 117 ). For a discussion of “monitor follow” see
Monitor Follow on page 93 .
3. Connect the required reference cables.
Video : Please see Video Reference on page 418 and Figure 49 on page 114 .
Audio : Please see AES Reference on page 419 and Figure 49 on page 114 .
Note The AES reference must always be terminated with a 75 ohm terminator, even
when not actively in use.
About AES Reference
The following information should be referenced when using AES reference:
• Grass Valley recommends that an AES reference is only used when it is
widely used in a facility for all AES audio sources. Otherwise, Grass
Valley recommends using the video reference alone, especially for
Embedded Audio applications.
• When Dolby-E audio is passed through the system, you must use an
interlaced video reference.
• When AES reference is used, the AES reference must be properly locked
to the video reference.
• The AES reference must always be terminated with a 75 ohm termi-
nator even when not actively in use.
• For systems using the AES Audio inputs and the Video Reference
input, you should use of a video reference that utilizes SMPTE S318M-
1999.
Installing the GUI Control Panel
Follow these steps to install the GUI Control panel:
1. Install the GUI control panel PC, PCI panel server and monitor.
Please refer to Figure 45 on page 99 for cabling information.
2. Install the hardware control panel (if supplied).
a. Mechanical installation:
The hardware control panel is designed to be flush-mounted in a
custom console. The console should be angled toward the operator