Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 267)

MAESTRO Installation and Service Manual 267
Log View
Log View
The user can show or hide the log view. The log view panel shows the
activity log and three buttons.
Figure 6 shows the Deployment Center with
the log view enabled.
Board Communication
Note Direct Board Communication via the Board Comm interface is NOT an oper-
ation that is typically performed by the end user. This functionality should
ONLY be attempted under the direction of Grass Valley’s Technical Support or
Engineering personnel.
When the Board Comm button is selected, the following section will be shown
next to the button:
Figure 159. Deployment Center Board Communication
The command drop-down list contains available commands that can be
sent to the board according to the current board state. Select a command
and click the
Send button to send the command. If a command requires
parameters, parameter text boxes will be displayed to allow the user to
enter the information.
To reboot a board, for example, do the following:
1. Select the preferred board(s) in the board list.
2. Select REBOOT from the Board Communication drop-down list.
3. Click Send to send the reboot command to the selected boards.
The control center always tries to push the board to the “Started” state. If
the user wants to manually stop the system, press the
Stop/Unload button.