Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 121)

MAESTRO — Installation and Service Manual 121
Touch Screen Calibration
Figure 54. PCI Panel Server Board
3. Press the PCI Panel Server gently down into the slot until you feel the
edge of the bus connector reach the bottom of the PCI slot.
4. Connect a PC power cable (a 4-pin Molex connector) to the panel server
power connector J4. Note that the Molex connector is keyed to be
inserted into the panel server’s power connector in only one direction.
5. Secure the rear metal bracket of the board to your computer case and
close the case.
6. Connect the PC to the system LAN as shown on page 99 .
Touch Screen Calibration
If a touch screen LCD and driver are installed, the touch screen must be cal-
ibrated.
Follow these steps to calibrate the touch screen:
1. Go to the Windows desktop and launch the TouchWare application.
2. Select Calibrate and then touch your finger on the target that appears.
3. Continue touching all targets that appear until calibration is complete.
4. Test the touch screen calibration. Repeat the above steps as needed.
8884_40
Bus connector
FAC (Facility) (LAN 1) port
CTL (Control) (LAN 2) port
Console port
Alarm
Reset
Bracket