Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 225)

MAESTRO Installation and Service Manual 225
7th Step: Effects Configuration
The available Enter effect choices are:
• PGM - The PGM source will end up in the PGM effect window and the
AUX source will end up in the AUX effect window. No sources inter-
change roles. This effect is often accomplished by PGM squeezing into
the PGM effect window revealing AUX squeezing into the AUX effect
window.
• AUX - The AUX source will end up in the PGM window and the PGM
source will end up in the AUX effect window. The PGM source and
AUX source will interchange roles, AUX source will become the PGM
source and PGM source will become the AUX source. This effect is often
accomplished by “un-squeezing” AUX on top of PGM with AUX
ending up in the PGM effect window and PGM squeezing into the AUX
effect window.
• PST - The PST source will end up in the PGM effect window and PGM
source will end up as PST. AUX will end up in the AUX effect window
and remain as AUX. PST and PGM will interchange roles. This effect is
often accomplished by performing a full screen transition from PGM to
an existing effect on PST.
Active Effect
Select an Active Effect. When an effect is active (on-air), the available Exit
modes will be determined by the selected active effect.
Note The default exit mode will be to reverse the process used to enter the effect.
In other words, if program was squeezed revealing the AUX video, the default
exit mode is to unsqueeze PGM video and return to PGM full screen. If AUX
video was unsqueezed over PGM, the default exit mode is to squeeze the
PGM (it was AUX when it was selected) until it disappears leaving the original
PGM video full screen. Other exit modes may be available depending on the
choices selected from the list below.