Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 390)

390 MAESTRO — Installation and Service Manual
Section 13 — DVE Configuration
To configure VBI PassThrough, do the following:
1. In the Configuration Editor, create one or more VBI PassThrough tables
by selecting “VBI PassThrough’ in the “7th Step: Effect Configuration”
area of the Configuration Editor.
Note A different VBI PassThrough definition can be assigned to each Maestro
channel. Create a VBI PassThrough table for each desired VBI PassThrough
definition
2. As VBI PassThrough configuration is dependent upon the video
standard, select the appropriate video standard for the new VBI
PassThrough definition as shown in
Figure 283 .
Note There is a known issue when configuring VBI PassThrough settings for the
575i50, 1080i50 and 1080i5994 standards. See the VBI Pass-Through Offset
Workaround section in the 2.0 version of the Maestro Release Notes.
Figure 283. VBI PassThrough Video Standard Selection
When a VBI PassThrough table is created, a table similar to that illustrated
in
Figure 140 on page 240 appears.
Note The VBI lines in the selected video standard are represented in the VBI
PassThrough table. Depending on the video standard selected, the VBI
PassThrough table may not be the same as illustrated in
Figure 140 on
page 240 .