Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 323)

MAESTRO — Installation and Service Manual 323
Section
9
Channel Branding Hardware
Installation
This section describes the procedures for installing the Channel Branding
option’s hardware which includes the Channel Branding mezzanine board
and disk drives.
CAUTION Before proceeding with the hardware installation, the software installation
procedures documented in the previous section must be followed. Of partic-
ular importance is
Checking the Boot ROM Versions . The boot ROM must be
the current version or the Maestro processor board may not start properly
with the Channel Branding Hardware installed.
Grass Valley recommends that you follow the Hardware Installation proce-
dure steps exactly. The procedure includes the following steps:
1. Channel Branding Board Installation .
• Removing the Channel Branding Boards from the Packaging .
• Fastening the Channel Branding Board to the Base Board .
2. Channel Branding Hard Drives Installation .
• Mounting and Formatting Drives (optional).
• Partitioning and Formatting a Drive (optional).
3. Installing the Content Gateway .
Channel Branding Board Installation
The following two sections will describe the Channel Branding Board
Installation process. You will need to remove the boards from the shipping
packaging and use the suspension trays during the installation process.
You must align the connectors with the holes on the Channel Branding
board with the connectors and screw post on the Maestro processor board;
then fasten them together.