Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 277)

MAESTRO Installation and Service Manual 277
Updating the System Configuration and Software
Figure 166. Processor Board FPGA/CPLD Update Menu
This menu shows the names of all of the FPGAs/CPLDs on the pro-
cessor and the version number of the gateware that is currently running
(or is “loaded”) in each device. A few of the FPGA-type components
and all of the CPLD-type components can be updated using this menu.
If a newer (“current”) version of gateware is available for those compo-
nents, the menu will indicate the new version number and display a
check box in the Update column.
Note A Current version may have a smaller number than the corresponding Loaded
version. A Current version may have a smaller number than the corre-
sponding Loaded version. If FPGA/CPLD updates were performed with
Maestro software versions 1.500, there will be no available FPGA/CPLD
updates with v1.5.1
c. Check the “Select All” box if there are available updates.
Note Do not check “Gennum A” or “Gennum B” if no DVE board is installed. Doing
so will cause the update to fail.
d. Select Update .
You will be asked to confirm the update.
CAUTION The following step will interrupt the video and audio signals passing through
the system.
e. Answer Yes .