Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 392)

392 MAESTRO — Installation and Service Manual
Section 14 — Maestro Content Manager Service Configuration
Figure 284. Maestro Control Management Center Icon
Or
Click the Maestro Content Manager Center icon in the Start Menu
(Start> All Programs> Thomson> Maestro Content Manager Center).
The Maestro Content Manager Center application will then open
(
Figure 285 ).
Figure 285. Maestro Content Management Center Application
Selecting the Content Manager Server
You will need to select the Content Manager Server’s Facility (or the NIC
card’s) IP address. See your IT department for this information.
Follow these steps to select the Content Manager Server:
1. Click the Browse & Select Server(s)... button, which is located on the left
side of the screen under the Server Information area. The Maestro
Content Manager Servers dialog will then appear.
2. Select the preferred server from the list. In Figure 286 shown below,
only one server is shown.
3. Select the Facility IP address from the drop-down list.