Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 143)

MAESTRO Installation and Service Manual 143
1st Step: Connections
RCS Connection
This screen has a table that is used to identify the Encore System Control
Board (SCB), Prelude control panel, or the Jupiter controller (CM-4000 or
VM-3000) that will be receiving commands from Maestro. Each feature of
the screen is described below.
Figure 69. RCS Connection Table
Name
Create a name for the controller. This is an arbitrary name that is only used
within the Maestro system.
This is the source of the RCS Connection name on the Channel Setup table,
as described on
page 242 .
Protocol
Select the appropriate protocol from the drop-down list. The appropriate
options are:
• Select the “Native Protocol” for Encore or Prelude control.
• Select “ES-Control (Serial)” for Jupiter control using a serial connection.
Note For Jupiter, the corresponding protocol setting for the target VM/CM port (on
the Serial Protocol table) is “ES Switch.”
• Select “ES-Control (LAN)” for Jupiter control using a LAN connection.
The “Mock” option is for factory testing.