Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 263)

MAESTRO Installation and Service Manual 263
Configuration Files
Software Application Box
This portion of the Control Center screen allows selection of software dis-
tribution files that are located on the deployment PC. After selection, these
files can be downloaded to the system hardware in preparation for activa-
tion at an appropriate time.
Configuration Files
See Configuration Files on page 262 for more information on the location and
structure of configuration files.
Configuration Box
This portion of the screen shows the name of the configuration set that is
currently active (running on the hardware). The configuration set is created
and edited using the configuration editor (as described in the previous
section of this manual). The preferred set is selected in the “File” drop-
down field. The
Update Only button is used to download the selected set to
the hardware. If the Update Only mode is used, the configuration set will
be downloaded but not executed. If the Update and Apply mode is used,
the configuration will be downloaded and activated on Maestro system.
CAUTION If the Update and Apply button is chosen, all signals passing through the
Maestro system will be a briefly interrupted while the configuration is acti-
vated on the Maestro processors.
You must reboot Maestro when you see a message that says the FTP failed
after pressing either the
Update button or the Update and Apply button to
upload a new configuration.
Board List
This table shows the software status of the system.
The fields that show the software status for the deployment PC have a blue
background. These fields show the software version of programs that are
available for download to the system hardware. There are four classes of
software shown: the Application software, the FPGA gateware, the
VXWorks operating system, and the Configuration set.