Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 312)

312 MAESTRO — Installation and Service Manual
Section 8 — Software Installation
Follow these steps to re-compile the Configuration file:
1. Launch the Maestro Configuration Editor by going to Start> All
Programs> Thomson> Maestro Configuration Editor.
2. Select the Maestro configuration set to be re-compiled by going to
“File> Open> Thomson” and selecting the set.
This should be the configuration set that was created for v2.4.0 use (see
Step 6 in the Making a Copy of the Maestro Configuration File section).
3. Check the indicated table(s) and make corrections as indicated if the
system displays a Validation Report.
You can use the links in the Description column to display the tables.
4. Save the configuration file.
5. Compile the file by going to “File> Compile Channel Data.”
6. Proceed to Updating the System Configuration and Software below.
Updating the System Configuration and Software
Follow these steps to update the system configuration and software:
1. Launch the Maestro Deployment control center by selecting “Start> All
Programs> Thomson> Maestro Deployment Center.
A Maestro Deployment Control Center window similar to that shown
in
Figure 211 appears.