Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 292)

292 MAESTRO Installation and Service Manual
Section 7 — Prelude Control System Interface
Figure 183. The NP Server Configuration Window
3. Enter or modify the name of the client. In this example, “mae-pc” is
used.
4. Click the IP Address field and enter the appropriate address and then
click the
Save button. An alert may appear, click the Yes button.
Figure 184. The NP Server Configuration Window
5. Right click the Client Name field in the Ethernet #2 column. Select
either new or edit. The NP Client Configuration window will then
appear. In this example, “mae-fp” is used.
6. Click the IP Address field and enter the appropriate address.
7. Click the Refresh Rate field and enter “60” in the field ( Figure 184 ).
Click the Save button. The window will then close
8. Click the Save button. The Prelude window will then appear informing
you that you must send the config file to the control panel. Click the Ok
button.
9. Repeat the above steps for each Maestro frame processor that will be
controlled through this or a redundant panel.