Grass Valley Maestro Master Control Installation v.2.4.0 - Manual (Page 377)

MAESTRO — Installation and Service Manual 377
The available choices are:
• Exit->PGM : This exit mode unsqueezes the source in the squeeze
window (PGM) leaving the PGM video full screen.
• Exit->PST : This exit mode replaces the on-air effect with the video
selected on the PST bus.
• Exit->AUX : This exit mode squeezes the squeeze window (PGM) until
it disappears leaving only the background video (AUX) on screen. At
the end of the transition, AUX video moves to the PGM bus.
• AudioOnly : This exit mode transitions only the audio. The active video
effect is unchanged. The audio that will be on-air after pressing the TAKE
button is selected with the DVE Audio Mode button. Available audio
modes are determined by the “Available Audio Mode” selections
explained below.
• AUX<->PST : This is a transition that replaces the current background
video (AUX) with the video selected on the PST bus.
• SwapPGMAUX : This is a cut-only transition that swaps the back-
ground (AUX) and squeeze window (pgm) video. The selected transi-
tion rate and type are disabled.
• PST>PGM>AUX : This cut-only transition rotates the sources on all
three busses in the direction indicated by the “>.” The selected transi-
tion rate and type are disabled.
• PST : This cut-only transition rotates the sources on all
three busses in the direction indicated by the “>.” The selected transi-
tion rate and type are disabled.
Figure 271. DVE Active Effect Selections
To make any or all of the choices above available once an effect is active,
click on the preferred effects (Hold down the
CTRL key while clicking to