Summary of changes, New and updated information, Summary of changes new and updated information – Rockwell Automation 21G PowerFlex 750-Series AC Drives Programming Manual User Manual
Page 3

Rockwell Automation Publication 750-PM001J-EN-P - October 2014
3
Summary of Changes
New and Updated Information
This table contains the changes made to this revision.
Topic
Page
The PowerFlex 753 and PowerFlex 755 flashing yellow STS status description changed.
Main DC Bus Volt parameter moved to the Metering Group.
The following parameters have new descriptions or default, minimum, and/or maximum
values have changed.
[Commanded Trq]
[Motor Ctrl Mode]
[Mtr Options Cfg]
[DI Precharge]
[SpdTrqPsn Mode D]
[Manual Cmd Mask]
[FlyingStart Mode]
[Pwr Loss B Level]
[Notch Fltr Atten]
[Psn Reg Ki]
[Psn Reg Kp]
[Homing Control]
[DLX Out 01]…
[DLX In 01]…
[DLX In 14]
[Enc Out FD PPR]
52
55
56
73
86
88
92
102
127
147
147
136
243
243
286
Motor control parameter
[Mtr Options Cfg] default setting for Jerk Select changed.
Motor control parameter
[Break Frequency] has the Voltage to Frequency table added.
Motor control parameter
[PM Cfg] has a table added.
Feedback & I/O parameters
[Dl SpTqPs Sel 0 and
[Dl SpTqPs Sel 1] has a table added.
Units for the following parameters were added.
[TO0 On Time]
[TO0 Off Time]
[Anlg Out0 Stpt]
The following parameters have been added.
[CbFan TotalLife]…
[CbFan RemainLife]
[HSFan TotalLife]…
[HSFan RemainLife]
[InFan TotalLife]…
[InFan RemainLife]
[CRC Flt Cfg]
[UserData Int 00…UserData Int 31]
[UserData Real 00…UserData Real 31]
, 1904…1928 [ScaleBlk Sel 00…07]
, 1905…1929 [ScaleBlk Scal 00…07]
, 1906…1930 [ScaleBlk Int 00…07]
, 1907…1931 [ScaleBlk Real 00…07]
105
106
107
212
212
212
212
212
212
213
Diagnostics parameter
[Drive Status 1] table changed.
Removed “755” icon from parameters 1153 [Dead Time Comp] and 1154 [DC offset Crtl].
Universal feedback parameter
[FBO Device Sel] options changed.
Descriptions for the following event numbers have changed.
24 “
”
27 “
35 “
”
211 “
”
901…927 “
”
The following event numbers were added.
333 “
”
343 “
”