Rockwell Automation 21G PowerFlex 750-Series AC Drives Programming Manual - Manual (Page 13)

Rockwell Automation Publication 750-PM001J-EN-P - October 2014 13
Preface
Product Safety
Class 1 LED Product
ATTENTION: An incorrectly applied or installed drive can result in component damage
or a reduction in product life. Wiring or application errors such as under sizing the
motor, incorrect or inadequate AC supply, or excessive surrounding air temperatures
may result in malfunction of the system.
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive parts and
assemblies. Static control precautions are required when installing, testing, servicing or
repairing this assembly. Component damage may result if ESD control procedures are
not followed. If you are not familiar with static control procedures, reference Guarding
Against Electrostatic Damage, publication 8000-4.5.2 or any other applicable ESD
protection handbook.
ATTENTION: Configuring an analog input for 0-20 mA operation and driving it from a
voltage source could cause component damage. Verify proper configuration prior to
applying input signals.
ATTENTION: A contactor or other device that routinely disconnects and reapplies the
AC line to the drive to start and stop the motor can cause drive hardware damage. The
drive is designed to use control input signals that will start and stop the motor. If an
input device is used, operation must not exceed one cycle per minute or drive damage
will occur.
ATTENTION: Drive must not be installed in an area where the ambient atmosphere
contains volatile or corrosive gas, vapors or dust. If the drive is not going to be installed
for a period of time, it must be stored in an area where it will not be exposed to a
corrosive atmosphere.
ATTENTION: Hazard of permanent eye damage exists when using optical transmission
equipment. This product emits intense light and invisible radiation. Do not look into
module ports or fiber optic cable connectors.