Rockwell Automation 21G PowerFlex 750-Series AC Drives Programming Manual - Manual (Page 271)

Rockwell Automation Publication 750-PM001J-EN-P - October 2014 271
Embedded Feature and Option Module Parameters Chapter 5
Fil
e
Gr
ou
p
No. Display Name
Full Name
Description Values
Re
ad
-Write
Da
ta T
ype
D
u
al In
cr
emen
tal En
co
der
Encoder 1
11 Enc 1 Cfg
Encoder 1 Configure RW 16-bit
Integer
Configures the position direction, speed calculation method, signal type and active encoder channels used for Encoder 1 (secondary encoder).
Bit 0 “Z Channel Enbl” – Configures the Channel Z to be used and monitored for Phase Loss. A value of 0 = the Z channel will be ignored.
Bit 1 “A Chan Only” – Configures the module to use only the A channel, and ignore the B channel. In this mode, direction cannot be determined, and the position
counter will always count up.
Bit 2 “Edge Mode” – Configure the module to use AB edge time data for speed calculation rather than accumulated count.
Bit 4 “Single Ended” – Configure when the A Quad B encoder has single ended signals. In this mode, Phase Loss detection is disabled. 0 = Differential, 1 = Single
Ended
Bit 5 “Direction” – Inverts the position count up/down associated with a given rotation direction internally. 1 = invert, 0 = do not invert
12 Enc 1 PPR
Encoder 1 Pulses Per Revolution
Configures the encoder module's secondary input (Encoder 1) for the Pulses Per
Revolution (Encoder Lines) of the A Quad B Encoder. Default:
Min/Max: 1024
2 / 20000 RW 32-bit
Integer
13 Enc 1 FB Lss Cfg
Encoder 1 Feedback Loss
Configures how the drive reacts to an error status condition for Encoder 1 (secondary
encoder).
“Ignore” (0) – No action is taken.
“Alarm” (1) – Type 1 alarm indicated.
“Flt Minor” (2) – Minor fault indicated. If running, drive continues to run.
Enable with P950 [Minor Flt Cfg]. If not enabled, acts like a major fault.
“FltCoastStop” (3) – Major fault indicated. Coast to Stop. Default:
Min/Max: 3 = “FltCoastStop”
0 = “Ignore”
1 = “Alarm”
2 = “Flt Minor“
3 = “FltCoastStop“ RW 32-bit
Integer
14 Enc 1 FB
Encoder 1 Feedback
Displays the position feedback value of Encoder 1 (secondary encoder). This should be
used as a source for the main control (Port 0) Feedback Select. Default:
Min/Max: 0
–/+2147483647 RO 32-bit
Integer
Options
Re
se
rv
ed
Re
se
rv
ed
Re
se
rv
ed
Re
se
rv
ed
Re
se
rv
ed
Re
se
rv
ed
Re
se
rv
ed
Re
se
rv
ed
Re
se
rv
ed
Re
se
rv
ed
Di
re
cti
on
Sin
gle
E
nd
ed
Re
se
rv
ed
Edge Mode A Ch
an
On
ly
Z C
ha
n
En
bl
Default 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
0 = Condition False
1 = Condition True