Lenze 8400 StateLine - Manual (Page 97)

Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
97
4 Device control (DCTRL)
4.3 Automatic restart after mains connection/fault...
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.3.2 Auto-start option "Inhibit at Lenze setting"
This function extension is available from version 06.00.00!
The "Inhibit at Lenze setting" auto-start option configurable via bit 4 of C00142 prevents the
change to the " SwitchedOn " status after the Lenze setting has been loaded and the controller is
enabled.
For a change to the "
SwitchedOn " status, the controller enable must first be deactivated after the
Lenze setting has been loaded. Only if the controller is enabled again afterwards, the status changes
to " OperationEnabled ":
[4-1] Example 1: Behaviour with activated auto-start option "Inhibit at Lenze setting" ( C00142 : Bit 4 = "1")
[4-2] Example 2: Behaviour with deactivated auto-start option "Inhibit at Lenze setting" ( C00142 : Bit 4 = "0")
 Loading of the Lenze setting not possible since controller inhibit not set.
 Controller inhibit via signal change by the user
 Loading of the Lenze setting via device command C00002/1 = "1"
 Controller enable via signal change by the user
 Controller inhibit and subsequent controller enable via signal change by the user
t
load
= time required for loading the Lenze setting
,QLW
5HDG\7R6ZLWFK2Q
6ZLWFKHG2Q
2SHUDWLRQ(QDEOHG
&
/$B1&WUOE&,QK
W
W
5)5
W
&
W
n
r o
p
W
ORDG
q
 Loading of the Lenze setting not possible since controller inhibit not set.
 Controller inhibit via signal change by the user
 Loading of the Lenze setting via device command C00002/1 = "1"
 Controller enable via signal change by the user
t
load
= time required for loading the Lenze setting
,QLW
5HDG\7R6ZLWFK2Q
6ZLWFKHG2Q
2SHUDWLRQ(QDEOHG
&
/$B1&WUOE&,QK
W
W
5)5
W
&
W
W
n
o
p
ORDG
q