Lenze 8400 StateLine - Manual (Page 696)

15 Parameter reference
15.2 Parameter list | C00490
696
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00490
C00495
C00496
C00497
Parameter | Name:
C00490 | Position encoder selection
Data type: UNSIGNED_8
Index: 24085
d
= 5E15
h
From version 12.00.00
Selection of the procedure of generating the actual position
 Encoder/feedback system
Selection list (Lenze setting printed in bold) Info
0 No sensor: nSpeedSetValue_a The position signal dnMotorPosAct_p is derived from the
speed setpoint nSpeedSetValue_a.
10 Encoder selection C495 or
nVoltageAngleAct_a
The position signal dnMotorPosAct_p is either calculated
from the set speed feedback (for C00495 > 0) or from the
speed signal nMotorSpeedAct_v (for C00495 = 0).
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00495 | Speed sensor selection
Data type: UNSIGNED_8
Index: 24080
d
= 5E10
h
Selection of the feedback system for the actual speed for motor control and display
 Encoder/feedback system
Selection list (Lenze setting printed in bold) Info
0 No sensor No sensor available for the actual speed detection
1 Sensor signal FreqIn12 Speed sensor signal is fed via the digital DI1 and DI2
inputs
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00496 | Encoder evaluation method DigIn12
Data type: UNSIGNED_8
Index: 24079
d
= 5E0F
h
From version 03.00.00
 Encoder/feedback system
Selection list (Lenze setting printed in bold) Info
1 Low-resolution encoder (StateLine) High-precision procedure for low-resolution encoders
(<=128 increments)
3 Edge-counting procedure Simple edge counting procedure with adjustable
scanning time ( C00425 )
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00497 | Filter time constant
Data type: UNSIGNED_16
Index: 24078
d
= 5E0E
h
From version 03.00.00
 Encoder/feedback system
Setting range (min. value | unit | max. value)
0.0 ms 500.0
Subcodes Lenze setting Info
C00497/1 1.0 ms FreqIn12: Encoder filter time
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10