Lenze 8400 StateLine - Manual (Page 821)

Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
821
15 Parameter reference
15.2 Parameter list | C02607
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C02607
Parameter | Name:
C02607 | Holding brake: Status
Data type: UNSIGNED_16
Index: 21968
d
= 55D0
h
Switching status of the holding brake control
 Holding brake control
Display area (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 Brake applied 1 ≡ Holding brake is completely closed
Bit 1 Brake released 1 ≡ Holding brake is completely released
Bit 2 Feedforward control active 1 ≡ Feedforward control for holding of the load via the
motor is active before the holding brake releases.
Bit 3 Closing active 1 ≡ The brake closing time ( C02589/1 ) expires
Bit 4 Forced release active 1 ≡ In case of automatic operation of the holding brake
control, the brake is directly released via the MCK input
bMBrakeRelease = TRUE
Bit 5 Release active 1 ≡ The brake release time ( C02589/2 ) expires
Bit 6 Setpoint synchronisation active 1 ≡ A speed setpoint at the MCK is approached along a
defined ramp after brake release
Bit 7 Signalling contact error
Bit 8
Reserved
Bit 9 Reserved
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Reserved
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT