Lenze 8400 StateLine - Manual (Page 600)

15 Parameter reference
15.2 Parameter list | C00003
600
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00003
C00005
Parameter | Name:
C00003 | Status of last device command
Data type: UNSIGNED_8
Index: 24572
d
= 5FFC
h
Status of the device command executed last ( C00002 ).
Note:
Before switching off the supply voltage after carrying out a device command, check whether the device command
has been carried out successfully via the status display!
 Drive control (DCTRL) : Device commands
Selection list (read only) Info
0 Successful Device command has been executed successfully.
1 Command unknown Device command implausible or unknown to the system.
2 Password protection Unauthorised access for requested device command.

Password protection
3 Time-out Device command could not be processed in the defined
time (timeout).
4 System fault
5 Command server assigned
6 Controller inhibit required
10 Memory module binding error  Device personalisation
11 Password too short  Password protection
12 Wrong password
13 Password already set
14 Password not assigned
20 Setting the hiperface position failed
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00005 | Application
Data type: UNSIGNED_16
Index: 24570
d
= 5FFA
h
Selection of the technology application
Selection list
(Lenze setting printed in bold) Info
0 Wiring has changed This display appears if the FB interconnection has been
changed in the application level using the FB Editor.
1000 Actuating drive speed This technology application is used to solve speed-
controlled drive tasks, e.g. conveying belts.

TA "Actuating drive speed"
1100 Actuating drive speed (AC Drive
Profile)
From version 13.00.00
This technology application is used to solve speed-
controlled drive tasks, e.g. conveying belts.
The process data word received by the master control is
interpreted as "AC Drive Profile" control word.

TA "Actuating drive speed (AC Drive Profile)"
3000 Switch-off positioning From version 04.00.00
This technology application is used to solve speed-
controlled drive tasks which require a pre-switch off or
stopping at certain positions, e.g. roller conveyors and
conveying belts. This is implemented by connecting
switch-off sensors.

TA "Switch-off positioning"
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1