Lenze 8400 StateLine - Manual (Page 775)

Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
775
15 Parameter reference
15.2 Parameter list | C01000
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C01000
C01001
Parameter | Name:
C01000 | MCTRL: Status
Data type: UNSIGNED_16
Index: 23575
d
= 5C17
h
From version 10.00.00
Display area (min. hex value | max. hex value)
0x0000 0xFFFF
Value is bit-coded: Info
Bit 0 SLPSM: Speed closed-loop control 1 ≡ The sensorless control for synchronous motors is in
the closed-loop controlled operation (|n
Setpoint
| >
n
C00996
).
 Sensorless control for synchronous motors (SLPSM)
Bit 1 SLPSM: Speed open-loop control From version 12.00.00
1 ≡ The sensorless control for synchronous motors is in
the open-loop controlled operation (|n
Setpoint
| > n
C00996
).
 Sensorless control for synchronous motors (SLPSM)
Bit 2 Motor ASM From version 12.00.00
1 ≡ Set motor type is "Asynchronous motor"
Bit 3 Motor PSM From version 12.00.00
1 ≡ Set motor type is "Synchronous motor"
Bit 4 Encoder open circuit: V/f linear active From version 15.00.00
1 ≡ Due to an encoder open circuit, it has been internally
switched to the encoderless V/f characteristic control to
avoid impermissible motor movements.
Bit 5 Reserved
Bit 6 Reserved
Bit 7 Reserved
Bit 8 Reserved
Bit 9 Reserved
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 Reserved
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT
Parameter | Name:
C01001 | Manual entry of motor type
Data type: UNSIGNED_8
Index: 23574
d
= 5C16
h
From version 14.00.00
Selection list
0 Automatic
1 ASM
2 PSM
Subcodes Lenze setting Info
C01001/1 0: Automatic Manual entry of motor type
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1