Lenze 8400 StateLine - Manual (Page 622)

15 Parameter reference
15.2 Parameter list | C00106
622
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00106
C00107
C00114
Parameter | Name:
C00106 | Auto DCB: Hold time
Data type: UNSIGNED_32
Index: 24469
d
= 5F95
h
Hold time of the automatic DC injection brake
• The DC injection brake is applied for the time set here if the value falls below the speed setpoint set in C00019 .
 DC-injection braking
Setting range (min. value | unit | max. value) Lenze setting
0.000 s 999.000 0.500 s
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C00107 | DC braking: Hold time
Data type: UNSIGNED_32
Index: 24468
d
= 5F94
h
Maximum hold time of the manual DC injection brake
• A time can be set here after which the DC injection brake is switched off automatically to prevent the motor from
thermal overload.
• When "999.000 s" is set, the hold time is infinite.
 DC-injection braking
Setting range (min. value | unit | max. value) Lenze setting
0.000 s 999.000 999.000 s
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1000
Parameter | Name:
C00114 | DigInX: Inversion
Data type: UNSIGNED_16
Index: 24461
d
= 5F8D
h
The polarity of each digital input of the device can be inverted via this bit field.
 Digital terminals
Setting range (min. hex value | max. hex value) Lenze setting
0x0000 0xFFFF 0x0000 (decimal: 0)
Value is bit-coded: ( = bit set) Info
Bit 0  DI1 inverted Inversion of digital input 1
Bit 1  DI2 inverted Inversion of digital input 2
Bit 2  DI3 inverted Inversion of digital input 3
Bit 3  DI4 inverted Inversion of digital input 4
Bit 4  Reserved
Bit 5  Reserved
Bit 6  Reserved
Bit 7  Reserved
Bit 8  Reserved
Bit 9  Reserved
Bit 10  Reserved
Bit 11  Reserved
Bit 12  Reserved
Bit 13  Reserved
Bit 14  Reserved
Bit 15  CInh inverted Inversion of digital input RFR (controller enable)
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT