Lenze 8400 StateLine - Manual (Page 672)

15 Parameter reference
15.2 Parameter list | C00366
672
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00366
C00367
Parameter | Name:
C00366 | Number of CAN SDO channels
Data type: UNSIGNED_8
Index: 24209
d
= 5E91
h
Functional change from version 05.01.00 onwards
Selection of the number of active parameter data channels
• Up to and including version 05.00.00 , the parameter channels 1 and 2 are activated in the Lenze setting.
• From version 05.01.00 onwards , only the parameter data channel 1 is activated in the Lenze setting according to
CANopen. In order to activate both parameter data channels according to the previous behaviour, set
"2 SDO Lenze".
 System bus "CAN on board"
Selection list (Lenze setting printed in bold)
0 1 SDO CANOpen
1 2 SDO Lenze
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00367 | CAN SYNC Rx identifier
Data type: UNSIGNED_16
Index: 24208
d
= 5E90
h
Identifier by means of which the sync slave is to receive sync telegrams.
• Mapping of the CANopen object I-1005 (see DS301 V4.02).
 "CAN on board" system bus
Setting range (min. hex value | max. hex value) Lenze setting
0x0000 0xFFFF 0x0080 (decimal: 128)
Value is bit-coded: ( = bit set)
Bit 0  COBID Bit0
Bit 1  COBID Bit1
Bit 2  COBID Bit2
Bit 3  COBID Bit3
Bit 4  COBID Bit4
Bit 5  COBID Bit5
Bit 6  COBID Bit6
Bit 7  COBID Bit7
Bit 8  COBID Bit8
Bit 9  COBID Bit9
Bit 10  COBID Bit10
Bit 11 
Reserved
Bit 12  Reserved
Bit 13  Reserved
Bit 14  Reserved
Bit 15  Reserved
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT