Lenze 8400 StateLine - Manual (Page 615)

Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
615
15 Parameter reference
15.2 Parameter list | C00065
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C00065
C00066
C00070
C00071
Parameter | Name:
C00065 | Supply voltage 24V
Data type: INTEGER_16
Index: 24510
d
= 5FBE
h
Display of the 24V supply voltage for the supply of the control electronics
Note:
The 24 V supply for the control electronics is either provided by an external supply or by the controller itself if it is
connected to the mains voltage.
Display range
(min. value | unit | max. value)
0.0 V 3276.7
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10
Parameter | Name:
C00066 | Thermal motor load (I²xt)
Data type: INTEGER_16
Index: 24509
d
= 5FBD
h
Display of the thermal motor load, sensorlessly determined using a motor model
• If the value displayed here exceeds "100.00 %", the error message "OC6: Thermal motor overload (I2xt)" is output
and the fault response set in C00606 is executed (default setting: "Warning").
 Motor overload monitoring (I2xt)
Display range (min. value | unit | max. value)
0.00 % 199.99
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00070 | Vp speed controller
Data type: UNSIGNED_16
Index: 24505
d
= 5FB9
h
Amplification factor Vp of the speed controller for different motor control modes
Setting range
(min. value | unit | max. value)
0.00 600.00
Subcodes Lenze setting Info
C00070/1 15.00 SLVC : Vp speed controller
C00070/2 6.00 Reserved
C00070/3 3.00 SLPSM : Vp speed controller
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00071 | Ti speed controller
Data type: UNSIGNED_16
Index: 24504
d
= 5FB8
h
Reset time Ti of the speed controller for different motor control modes
Setting range
(min. value | unit | max. value)
0.0 ms 6000.0
Subcodes Lenze setting Info
C00071/1 100.0 ms SLVC : Ti speed controller
C00071/2 50.0 ms Reserved
C00071/3 100.0 ms SLPSM : Ti speed controller
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 10