Lenze 8400 StateLine - Manual (Page 34)

2 Introduction: Parameterising the controller
2.3 General notes on parameters
34
Lenze · 8400 StateLine · Reference manual · DMS 12.0 EN · 06/2014 · TD05/TD14
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.3.4 User menu for quick access to frequently used parameters
When a system is installed, parameters must be changed time and again until the system runs
satisfactorily. The user menu of the controller contains a selection of frequently used parameters to
be able to access and change these parameters quickly:

Tip!
The user menu can be freely configured in
C00517 .
In the »Engineer«, you can configure the user menu comfortably via the User menu tab (see
»Engineer« online help).
The
password protection serves to restrict the access to parameters of the user menu. Then,
all other parameters cannot be accessed without knowing the password and are thus
protected against unwanted changes.
Parameter Name Lenze setting
C00051 MCTRL: Actual speed value -
C00053 DC-bus voltage -
C00054 Motor current -
C00061 Heatsink temperature -
C00137 Device status -
C00166/3 Mess. - status det. error -
C00011 Appl.: Reference speed 1500 rpm
C00039/1 Fixed setpoint 1 40.00 %
C00039/2 Fixed setpoint 2 60.00 %
C00012 Acceleration time - main setpoint 2.000 s
C00013 Deceleration time - main setpoint 2.000 s
C00015 VFC: V/f base frequency 50 Hz
C00016 VFC: Vmin boost 1.60 %
C00022 Imax in motor mode depending on the device power
C00120 Setting of motor overload (I 2 xt) 100.00 %
C00087 Rated motor speed 1460 rpm
C00099 Firmware version -
C00200 Firmware product type -
C00105 Decel. time - quick stop 2.000 s
C00173 Mains voltage 0: "3ph 400V / 1ph 230V"
Highlighted in grey = display parameter